Laboratory Conductivity Meter

System of intelligent operationTemperature compensation: Automatic/ManualIP54 waterproof.

Cell constant that can be programmedinput:
output:The conductivity meter is a water quality analysis instrument that was specifically designed for the automatic control and high-end water quality management of medical multi-effect distilled water systems, boiler bottom water, condensate water, and heat exchange systems that operate in higher temperature environments.input:
output:Benefits

A 6-inch LCD display screen with a high resolution.

The multi-reading feature enables continuous reading and auto-reading.Accurate results are guaranteed through automatic or manual temperature compensation.

The measurement endpoint is detected and secured by the auto-hold feature.

Storage of data fifty sets for each parameter.

The reset feature automatically restores all settings to their factory default settings.IP54 waterproof.1 point calibration with standard recognition.The cell constant is adjustable.Specificationsinput:
output:ConductivityRange - 0.00 μS/cm to 200 mS/cmResolution - a minimum of 0.01 μS/cm, with the ability to adjust the range.

Precision - ±1.0% FSReference Temperature: 25 ºCCalibration Points: Maximum of 1Standard Recognition - 84 μS/cm, 1413 μS/cm, and 12.88 mS/cm TDSRange - 0.00 mg/L to 100 g/LResolution: A minimum of 0.01 mg/L, with the ability to select a range.

Precision - ±1.0% FSinput:
output:TemperatureUnit: ºC Range: -5.0 to 110 ºC, 23.0 to 230 ºF

Resolution - 0.1 mm Accuracy - ±0.2 mm Measurement - 0.1 mmReading Mode: Continuous, Auto Read

Reading Prompts - Stable, Locked, ReadingTemporary Compensation: ATC, MTCdata management - data storage - each with 50 resultsInputs: - Conductivity with temperature probe - 5-pin aviation connector



Display options:

Backlight: Yes

Auto Shutdown: 300, 600, 1200, 1800, 3600 sec., off

IP Rating - IP54