Dental Laboratory Saw

Access the future

Time-saving and precise

Until recently, the small space between the preparation or the diverging alignment of the teeth necessitated the manual cutting of saw cuts on numerous models....input:
output:This method of operation is also highly time-consuming and poses an elevated risk of injury, as well as damage to the plaster model.input:
output:Conserve both time and moneyinput:
output:
The G2 Concept model was observed.90 seconds *Manually sawing180 seconds **



Determined during the practice test on a model with 11 segments or 10 saw cuts.input:
output:Working method

The model that is to be sawn is secured to the saw table using two hands.The cut can be precisely positioned with the assistance of the integrated line laser.

The saw blade enters the model from below and establishes a clean cut parallel to the pins when the saw table is lowered.

The precise depth of cut can now be accurately determined optically, as the saw is sawn to the preparation limit and manually broken at the intended break site when the teeth are diverging.

All model segments can be effortlessly eliminated from the model due to the fact that the saw cuts are parallel.