Cutting Electrosurgical Unit

The Sensimatic 700SE is capable of faster cutting than a diode laser, resulting in less bleeding and better visibility1 of the treatment site than a scalpel. This simplifies and enhances the treatment outcomes of the procedures performed on a daily basis in your dental office.Monopolar for the precise cuts.Ten power settings.
Three cutting modes are available: CUT, CUT/COAG, and COAG.The electrode wire can be modified to accommodate the clinical contour requirements.Frequency of operation: 1.4 to 1.7 MHz.
The maximum power output is 50 watts.Advantages of Electrosurgery Over a Diode Laser

Clinical contour requirements can be accommodated by adjusting thin wire electrodes.The electrode wire's side can be used to cut in addition to the tip, as the tip is the only active cutting surface in a diode laser.Procedures are completed in a fraction of the time required to perform the same procedure with a diode laser.A broader, more adaptable selection of cutting tips.Reduce the initial cost of the device.
Please be advised that the handpiece (D702) and indifferent plate cable (D703) are exclusively compatible with Sensimatic units (D700SE-110) with serial numbers #90000 and higher, and (D700SE-230) with serial numbers #80000 and higher. Before placing an order for accessories, please verify the serial number that is situated at the base of your device.